Clarke CLS400 Especificaciones descargar pdf (Pagina 12)

Parts & Service: 020 8988 7400/E-mail:Part[email protected] or [email protected]

3. Turn the blade gently by hand

and check it is passing cleanly

through the gap in the cradle

without touching.

If not correct, the blade can be

correctly aligned by loosening the

four bolts holding the motor to the

motor support plate (shown in fig

10), and adjusting the motor in the

desired direction.

• Locknuts are used to retain the

fixing bolts permanently to the

Removable Guard.

3. Attach the Removable Guard

using the M6 x 45 mm bolts (these

should be secured to the guard

by locknuts as shown, to prevent

their possible loss). Screw the bolts

into the fixing nuts welded to the

fixed guard.

INSTALLING THE HANDLES, PROTECTIVE PLATE & SUPPORT YOKE

FIXINGS REQUIRED:

Handles;- 4 x M5 x10 hex headed

screws

Protective Plate;-2 x M6 x 8

machine screws

1. Secure both the handles to the log

cradle with M6x10 hex headed

screws.

2. Attach the Protective Plate using 2

x M6 machine screws.

3. Insert the Log Support Yoke into

the cradle and position it as

required with the securing knob.

Slide in the Log Stop Bar into the

other end of the cradle and set it

in position as required by screwing

in the securing knob as shown on

page 13.

Removable

Guard

Fig 9

Adjustable

Bolts

Fig 10

Support Yoke

Fig 12

Log Stop Bar

Handle

Protective

Plate

Fig 11

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Clarke CLS400 Especificaciones Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Sierras circulares Clarke CLS400