Clarke CMS10S2 Instrucciones de operaciones descargar pdf (Pagina 22)

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

MAINTENANCE

CHANGING THE SAW BLADE

Install the appropriate saw blade. Do not use excessively worn blades. The

maximum rotation speed of the tool must not exceed that of the saw blade.

1. With the saw head in the raised

position and with the slide rails

locked, move the blade guard

release to allow the blade guard

to be rotated back as shown.

• The centre screw should be

visible through the cut-out in

the guard.

2. Push and hold down the blade

lock, then using the Hex. wrench

supplied, undo and remove the centre screw.

• The screw has a LEFT HAND THREAD (turn it CLOCKWISE to undo).

3. Pull off the outer flange followed by the saw blade.

NOTE: You should take this opportunity to thoroughly clean parts previously

inaccessible.

4. Replace the blade, ensuring it has the correct diameter and bore.

• Ensure also that all parts are perfectly clean and the blades’ teeth

point down at the front as shown in the picture above.

• Additionally, the blade MUST be rated with a maximum speed of at

least 6000 rpm.

• Please note that spare blades are available from Clarke

International. Please see your Clarke dealer.

5. Replace the outer flange and screw in the centre screw, remembering the

has a LEFT HAND THREAD - i.e. turn ANTICLOCKWISE to tighten.

WARNING: MAKE SURE THAT THE SAW IS SWITCHED OFF AND UNPLUGGED

FROM THE MAINS SUPPLY BEFORE FITTING OR REMOVING THE BLADE.

WARNING: THE BLADE MUST BE RATED TO AT LEAST 6000 RPM.

WARNING: NEVER PUSH THE BLADE LOCK IN WHEN THE MOTOR IS

RUNNING.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Sin comentarios

Clarke CMS10S2 Instrucciones de operaciones Pagina 22