Clarke Fusion 201 Manual del operador Pagina 24
- Pagina / 64
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Page -24- Clarke
®
Operator's Manual -Fusion 20 Burnisher
HOW TO PREPARE THE MACHINE FOR OPERATION
How To Install The Batteries
The Fusion 20 machines use three 12-volt batteries.
The batteries are located in the battery compartment
under the battery cover.
To Install the batteries, follow this procedure:
1. Set the parking brake.
2. Remove the battery cover.
3. Remove the two screws that attach the
main body to the back of the frame, leaving
the two angle brackets attached to the main
body.
4. Remove the hose from the pad housing.
5. Remove the main body.
6. Place the batteries in the tray as shown in
figure13
WARNING: Lifting batteries without
help could result in an
injury. Get help to lift the
batteries. The batteries are
heavy.
WARNING: Working with batteries can
be dangerous. Always
wear eye protection and
protective clothing when
working near batteries.
NO SMOKING!
7. Connect the battery cables between
batteries as shown. See figure 13.
8. Join the connector from the battery pack to
the connector on the control panel. See
figure 14.
9. Reassemble machine.
NOTE: Charge the batteries before using the
machine.
Figure 13
Figura 13A
Figure 13B
Figure 14
BATTERY CONNECTIONS
To machine
power plug
Front of Machine
CONEXION DE LAS BATERIAS
Hacia el enchufe de
alimentación de la
máquina
Parte delantera de la máquina
ROJO
NEGRO
CONNEXIONS DES BATTERIES
Vers la fiche
d'alimentation
de la machine
Avant de la machine
ROUGE
NOIR
- 20I/20IX 1
- Table of Contents 2
- I N D I C E 3
- I N D E X 4
- OPERATOR SAFETY INSTRUCTIONS 5
- Starting with Serial #AJ1304 11
- TRABAJAR 27
- MISE EN SERVICE 27
- HOW TO PREPARE THE MACHINE 28
- O FUME ! 29
- OPERATION 30
- MAINTENANCE 38
- Fusion 20 I and 20 IX 42
- Nut, Jam ½-20 8xx 43
- (See *) 2 x x 43
- Fusion 20 IX 44
- Assembly Drawing #2 10/02 44
- Fusion 20 IX 45
- Fusion 20 I and 20 IX 47
- Assembly Drawing #4 11/01 48
- Beginning with Serial No. XD 48
- Assembly Drawing #5 8/02 50
- Assembly Drawing #6 8/02 52
- Transaxle 11/01 56
- Fusion 20 I 58
- Electrical Schematic 1/98 58
- Electrical Schematic 5/99 60
- Connection Diagram 9/98 61
- Connection Diagram 1/98 62
- , Springdale, Arkansas 63
- LIMITED U.S. WARRANTY 64
Relacionado con productos y manuales para Suelo Por Las Máquinas Clarke Fusion 201
(73 paginas)
(23 paginas)Supra F-1000 BP-R manuels
Manuels d'utilisation et guides de l'utilisateur pour Sports et loisirs Supra F-1000 BP-R.
Nous fournissons des manuels en pdf 1 Supra F-1000 BP-R à télécharger gratuitement par type de document : Manuel de l'utilisateur
Comentarios a estos manuales