Clarke TFC 400 Especificaciones descargar pdf (Pagina 8)

MAINTENANCE

1) Use only approved chemicals at the recommended mix ratios. All chemicals should be added through the feed system and NOT added

directly to the water in the solution tank to prevent possible damage to the pump, seals, or other components.

2) For optimum performance, ﬂ ush the Chemical Feed lines after every job by replacing the chemical containers with containers of clear water

and spraying through the gun until the ﬂ uid stream is clear. See the Maintenance Schedule, below.

3) The pump seals and/or valves in the high pressure pumps may need to be replaced after about 1000 hours of use, if the pump begins to

loose performance or to leak. The pressure regulator valve may need to be when a drop in the spraying pressure at the tool is apparent.

4) If the 4”, clear lid is removed from the top of the base (solution tank), you will need to apply a silicone sealant to the threads when you

reinstall the lid to seal for vacuum leaks.

MAINTENANCE SCHEDULE

ITEM DAILY WEEKLY QUARTELY YEARLY

Flush chemical lines X

Check/clean vac inlet ﬁ lter X

Clean solution ﬁ lter X

Check vacuum motor airways X

Check pump for leaks X

Check vacuum motor brushes* X

* Have Clarke check the carbon brushes once a year or after about 500 hours of operation.

TECHNICAL SPECIFICATIONS (as installed and tested on the unit)

MODEL 56380773

VACUUM MOTOR: 2 stage, 8 amp

WATER LIFT: 97”

AIR FLOW: 100 CFM

TANK CONSTRUCTION: Rotationally molded polyethylene

SOLUTION TANK CAPACITY: 20 gallon

RECOVERY TANK CAPACITY: 13 gallon

APPLICATION FLOW: 400 psi

VAC & SOLUTION HOSE LENGTH: 25 feet

POWER CORD: 25 feet

HEIGHT: 38.5 inches

WIDTH: 21.25 inches

LENGTH: 34 inches

WEIGHT 92 LBS

A-8 TFC 400 - 56380889 11/09

INSTRUCTIONS FOR USEA - ENGLISH

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Sin comentarios

Clarke TFC 400 Especificaciones Pagina 8