Clarke CR 28 Boost Manual del operador Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 66
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
ENGLISH
Operators Manual - CR 28 BOOST
®
15
MACHINE OPERATION (SCRUBBING/DRYING)
Start the machine as shown in the previous paragraph.1.
If necessary, adjust the solution ow sent to the brushes by pressing the switches (40).2.
NOTE
For correct scrubbing/drying of oors at the sides of the walls, Clarke suggests to go near the walls with the right side of
the machine as shown in gure 2.
B
A
Figure 2
P100160
Squeegee adjustment
If necessary, stop the machine and adjust the squeegee with the handwheel (16) so that the rear blade touches the oor along 3.
all its length.
WARNING!
To avoid any damage to the oor surface, turn off the BOOST
®
deck when the machine stops in one place,
especially when the extra pressure function is on.
Working with the BOOST
®
deck extra pressure function turned on
If the dirt on the oor proves to be particularly dif cult to clean, it is possible to work with an extra pressure of the BOOST4.
®
deck on the oor by pressing the switch (35).
To return to normal pressure, press the switch (35) again.5.
The switch (35) is enabled only when the deck (4) is lowered and the switch warning light (34) is on.
CAUTION!
In case of brush motor overload due to BOOST
®
deck excessive pressure or too aggressive oors/brushes, a
safety system stops the BOOST
®
deck after about one minute of continuous overload.
The overload is shown by the three warning lights (37a, 37b, 37c) ashing simultaneously.
If the overload takes place when cleaning with the extra pressure function activated, the system automatically re-
duces the pressure on the brush by deactivating the extra pressure function. If the overload persists, the BOOST
®
deck stops.
To start again after the BOOST
®
deck stop due to overload, stop the machine by turning the ignition key (41) to
“0”. Turn on the machine by turning the ignition key (80) to “I”.
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 65 66

Comentarios a estos manuales

Sin comentarios