Clarke Clean Track L18 Especificaciones descargar pdf (Pagina 17)

ENGLISH / A-17

FORM NO. 56041660 - Clean Track

16, 18 - A-17

AUTHORIZED PERSONNEL MAINTENANCE

BRUSH DRIVE BELT REPLACEMENT

1 Drain the recovery and solution tanks and tip the machine over onto its side.

2 See Figure 8. Remove the (2) (A) Screws.

3 Tip the machine back upright, grab hold of the Operator’s Handle (1) and push down to tilt the entire recovery / solution tank assembly back.

4 See Figure 12. Remove the (3) (A) Screws and then remove the Belt Guard (B).

5 Remove the Belt from the motor pulley.

6 Refer to the Removing the Brush section to remove the brush from the machine.

7 See Figure 13. Remove the Pulley Cover (A) and then slide the Pulley Block and Belt (B) out the bottom of the base housing.

8 Follow the above steps in reverse order to install the belt. NOTE: Refer to Instruction Sheet 56040906 for belt installation instructions.

FIGURE 13

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 79 80

Sin comentarios

Clarke Clean Track L18 Especificaciones Pagina 17