Clarke Clean Track L18 Especificaciones descargar pdf (Pagina 18)

A-18 / ENGLISH

A-18 - FORM NO. 56041660 - Clean Track

16, 18

AUTHORIZED PERSONNEL MAINTENANCE

VACUUM MOTOR MAINTENANCE

This machine has a vacuum motor that uses carbon brushes. The carbon brushes in the motor must be checked once a year, or every 300 hours of

operation, whichever comes ﬁ rst. If either of the brushes is shorter than 3/8 inch, replace both of the carbon brushes.

To gain access to the vacuum motor:

1 Drain the recovery and solution tanks and tip the machine over onto its side.

2 See Figure 8. Remove the (2) (A) Screws.

3 Tip the machine back upright, grab hold of the Operator’s Handle (1) and push down to tilt the entire recovery / solution tank assembly back.

4 Disconnect the vacuum motor wiring and tip the recovery / solution tank assembly back forward. NOTE: Make note of wire connection

locations for reassembly.

5 Disconnect the Recovery Hose Connection (19).

6 See Figure 14. Remove the (4) Button Plugs (A) and the (4) Screws and Washers (B).

7 Lift the Recovery Tank (3) off of the machine.

8 Lift the Vacuum Motor (C) up and out of the Solution Tank.

FIGURE 14

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 79 80

Sin comentarios

Clarke Clean Track L18 Especificaciones Pagina 18